Sadly, some weeks ago, the Micro USB Port of my HDMIPi broke.
I wrote an letter to Alex Eames, which is quite known for HDMIPi, RasPi.TV and his lattest Kickstarter Project the RasPiO Duino.
Alex is an awesome guy and gave me his blessings to try to repair that problem myself.
With some flux, a fine solder tip and soem patience, you can get that repaired in no time.
After succeeding, I created some strain-relief by using two-component epoxy resin to glue it down a bit. Highly recommended!
As I already saw the unused VGA pinout on the HDMIPi and had the screen taken apart, I decided to hack an old VGA Connector from an even older VGA ATI/S3 Trio/Dunno-something-very-old Graphics Card :). I just soldered it in - in it worked right away! However, due to the fact of the included 12mm M3 Spacers and the additional height of the board due to the VGA Connector, I could not attach the back plate of the HDMIPi. I don't recall the exact size, but I think I came up with 18mm M3 Spacers which I only used to replace the original 3 Spacers on the bottom part of the HDMIPi. That way, the buttons of the Display would still be seated nicely and I could access the GPIO Ports of the RPi quite well.
Some photos:
