Tag: Factory

[79XX] Cisco IP Phone Factory Reset & Reboot

To Factory Reset a Cisco IP Phone do the following:
1. Press and hold #, disconnect and reconnect Power
2. The Phone will check through the Line LEDs, on an 7911 or similar it will just light up the both Menu Keys and the Reciever \ Handset LED - after that, let go of #
3. Enter following: 1 2 3 4 5 6 7 8 9 * 0 #
4. The Phone should start up and grab the latest config from your Callmanager

To just Reboot a Cisco IP Phone do following:
1. Go into any Menu
2. Enter #
3. Phone does reload
( 7940, 7960: Hold *,6,Settings )

To open up the Configuration on a Phone:
1. Go into Menu Setting
2. Enter **##

To Factory Reset and erase the firmware on a Cisco IP Phone do the following:
1. Press and hold #, disconnect and reconnect Power
2. The Phone will check through the Line LEDs, on an 7911 or similar it will just light up the both Menu Keys and the Reciever \ Handset LED - after that, let go of #
3. Enter following: 3 4 9 1 6 7 2 8 5 0 * #
4. The Phone should start up and grab the latest Firmware from your Callmanager

Astaro Security Gateway v7 Factory Reset

Access to SSH or console with root passwords:

/etc/init.d/factoryreset reset
No Access to SSH or root passwords are lost:

Connect a keyboard and monitor to the system.
Wait for boot prompt
Enter:
boot: default factoryreset

After that you can go to your during the installation definied IP like: https://192.168.0.1

Alternativ:

1. Boot on the ASG from a Knoppix CD
2. Login as root
3. Mount the root partition of the ASG with: mount –t ext3 /dev/sda7 /mnt
4. Go to the config on the ASG: cd /mnt/etc/wfe/conf/; vim setting
5. Change reset_pwd = 0 to reset_pwd = 1
6. Save
7. Run cd /; umount /mnt; reboot
8. Access the install IP